Mobile: +86 181 2678 7728
Tel: +86 769 8163 1488
Fax: +86 769 8163 1611
Add: 2nd Industrial Park, HuanBaoNan Road, ShaTian, DongGuan, GuangDong, P.R.C.
Shotblast belt slip is often encountered problems, then why there is such a problem? Encounter this problem, how to do?
Lifting machine is an important shot blasting machine accessories, shot blasting machine determines the normal operation, the use of shot blasting machine project may encounter a large belt pulley skid blasting friction occur, at this time we should promptly Analysis of the reasons for troubleshooting, for everyone to summarize the shot blasting machine belt slippage occurred greater friction bump sound reasons generally have three points:
1, belt slack, adjusting the upper part of the elevator to adjust the screw bolt tension tight.
2, the hoist does not block the material, open the lower part of the inspection door, manually remove debris, boot in order.
3, to enhance the belt deviation, open the maintenance cover to enhance the upper part, observe the direction of belt deviation, adjusting the upper part of the hoist tension device, while adjusting a single test drive.