Tel: 18126787728
Categories
Contact us
Add: 2nd Industrial Park, HuanBaoNan Road, ShaTian, DongGuan, GuangDong, R.R.C.
Tel: +86-769-81631488
Fax: +86-769-81631611
E-mail: service@hongyipu.com
Mr Dan Lee: +8618126787728
Knowledge
Home > Knowledge > Content
Steps for replacement of crawler for shot blasting equipment
Jul 09, 2018

Previously, we introduced that crawler is an important vulnerable part of crawler pellet thrower. When the workpiece is constantly turning over, it will cause damage to the crawler. If it is used for a long time, it will reach the life of the crawler. Then, it needs to replace the crawler, here we will tell you the correct way to replace the crawler.


Here are 8 steps to replace crawler of shot blasting equipment:


Step 1: Open the round plate and the flower disc inside the chamber, generally, the fixed screws are in two side of the chamber cover, which can be seen when the cover is opened.


Step 2: Check the extent of crawler damage, whether there is a tear or fracture. In these two cases,  splint knife can be used to cut the crawler from left to right inside and start the crawler shot blasting machine. The crawler turns in a positive direction, and then the crawler can be pulled out on the machine.


Step 3: Roll the three drives apart and pull them out from one end.


Step 4: The crawler type needs to take out the supporting roller together. Before removing the supporting roller, the tightening screw in the lower left corner and the lower right corner of the equipment should be placed in the top position.


Step 5: Put the crawler into the cleaning room. For larger crawler, the top of the chamber can be opened and installed through hanging by steel wire. A hand-pulled gourd can also be fixed in the position of the impeller of the shot thrower to pull the crawler.


Step 6: After the crawler is placed in a fixed position, put the driving roller.


Step 7: Slowly adjust the position of the crawler after the screw is tightened, and fix the gate plate on the upper end of the screw after it is determined.


Step 8: After the new crawler is replaced, add lubricating oil on the bearing off active, passive drive roller to increase their service life.


  • Newsletter
  • Categories
  • Contact us
    Add: 2nd Industrial Park, HuanBaoNan Road, ShaTian, DongGuan, GuangDong, R.R.C.
    Tel: +86-769-81631488
    Fax: +86-769-81631611
    E-mail: service@hongyipu.com
    Mr Dan Lee: +8618126787728
  • QR Code
  • Copyright © GuangDong HongYi Polyuerthane Science & Technology Co.,Ltd All Rights Reserved.